How to measure
Bar pulls are specified by centres - the distance between the two fixing holes, not the overall length of the handle. Measure hole centre to hole centre.
Available centres
76 to 320 mm, depending on profile — 96, 128, 160, 192, 224, 256, 288 and 320 mm across the bar pulls, with the Vintage Pull adding a compact 76 mm. Each product page lists the sizes made for that profile.
Overall length
Overall length typically runs 32–40 mm longer than the centres, varying slightly by profile.
Knobs and T-bars
These are single-point fixings, so there are no centres to match - only the diameter or bar length.
If you are replacing existing handles
Match the centres exactly and you will not need to drill new holes.